Three Steps Into An Excellent Paint Job

There are 3 things you may neglect to perform that will destroy an otherwise ideal miniature painting service. A paint job, regardless of what paint you use, is very determined by the prep that’s performed before hand.

You just must do the following three items, or you may anticipate to see your paint peel, flake out, or spot.

1. You must wash off the dirt off the miniature, rather with a pressure washer.

2. You must eliminate any outdated loose sheeting and replace it with a latex caulk, not silicone. You must eliminate old silicone entirely; paint won’t adhere to silicone.

3. You must scrape the loose paint and sand the edges smooth.

Attempting to perform these easy but tedious jobs will destroy an otherwise ideal job. You’ll be spending a lot of money to paint your miniature; you would like it to look good for some time after you complete.

After rinsing off the miniature from the top to bottom with a pressure washer, remove any loose or flaking paint and simmer using a putty knife or paint scraper.

Next place new caulk in which you need that, particularly around doors and windows, and everywhere there’s flat trim. This will avoid water penetration during rain storms or sprinklers hitting on your residence.

Brush painting needs greater ability than it sounds. A steady hands and concentration are the keys. Don’t be a dauber! Lay paint in long strokes, starting about an inch off from items you would like ‘t need to paint, then the next stroke does exactly the detail.

When using a roller, then make sure you do a little part, then brush it to place brush lines from the paint. Then do a second section. In case you’ve got flat siding, then do the top two boards, five or four feet at a time, until you get to a cut off stage like a window. Struggling to carry through into some cut off line will lead to ugly lap marks.